Enum rp2040_pac::i2c0::ic_raw_intr_stat::ACTIVITY_A

pub enum ACTIVITY_A {
    INACTIVE = 0,
    ACTIVE = 1,
}

This bit captures DW_apb_i2c activity and stays set until it is cleared. There are four ways to clear it: - Disabling the DW_apb_i2c - Reading the IC_CLR_ACTIVITY register - Reading the IC_CLR_INTR register - System reset Once this bit is set, it stays set unless one of the four methods is used to clear it. Even if the DW_apb_i2c module is idle, this bit remains set until cleared, indicating that there was activity on the bus.

Reset value: 0x0

Value on reset: 0

Variants

INACTIVE = 0

0: RAW_INTR_ACTIVITY interrupt is inactive

ACTIVE = 1

1: RAW_INTR_ACTIVITY interrupt is active

Trait Implementations

impl Clone for ACTIVITY_A

fn clone(&self) -> ACTIVITY_A

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for ACTIVITY_A

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl From<ACTIVITY_A> for bool

fn from(variant: ACTIVITY_A) -> Self

Converts to this type from the input type.

impl PartialEq for ACTIVITY_A

fn eq(&self, other: &ACTIVITY_A) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for ACTIVITY_A

impl Eq for ACTIVITY_A

impl StructuralPartialEq for ACTIVITY_A