Enum rp2040_pac::i2c0::ic_enable_status::SLV_DISABLED_WHILE_BUSY_A

pub enum SLV_DISABLED_WHILE_BUSY_A {
    INACTIVE = 0,
    ACTIVE = 1,
}

Slave Disabled While Busy (Transmit, Receive). This bit indicates if a potential or active Slave operation has been aborted due to the setting bit 0 of the IC_ENABLE register from 1 to 0. This bit is set when the CPU writes a 0 to the IC_ENABLE register while:

(a) DW_apb_i2c is receiving the address byte of the Slave-Transmitter operation from a remote master;

OR,

(b) address and data bytes of the Slave-Receiver operation from a remote master.

When read as 1, DW_apb_i2c is deemed to have forced a NACK during any part of an I2C transfer, irrespective of whether the I2C address matches the slave address set in DW_apb_i2c (IC_SAR register) OR if the transfer is completed before IC_ENABLE is set to 0 but has not taken effect.

Note: If the remote I2C master terminates the transfer with a STOP condition before the DW_apb_i2c has a chance to NACK a transfer, and IC_ENABLE[0] has been set to 0, then this bit will also be set to 1.

When read as 0, DW_apb_i2c is deemed to have been disabled when there is master activity, or when the I2C bus is idle.

Note: The CPU can safely read this bit when IC_EN (bit 0) is read as 0.

Reset value: 0x0

Value on reset: 0

Variants

INACTIVE = 0

0: Slave is disabled when it is idle

ACTIVE = 1

1: Slave is disabled when it is active

Trait Implementations

impl Clone for SLV_DISABLED_WHILE_BUSY_A

fn clone(&self) -> SLV_DISABLED_WHILE_BUSY_A

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for SLV_DISABLED_WHILE_BUSY_A

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl From<SLV_DISABLED_WHILE_BUSY_A> for bool

fn from(variant: SLV_DISABLED_WHILE_BUSY_A) -> Self

Converts to this type from the input type.

impl PartialEq for SLV_DISABLED_WHILE_BUSY_A

fn eq(&self, other: &SLV_DISABLED_WHILE_BUSY_A) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for SLV_DISABLED_WHILE_BUSY_A

impl Eq for SLV_DISABLED_WHILE_BUSY_A

impl StructuralPartialEq for SLV_DISABLED_WHILE_BUSY_A