Enum rp2040_pac::i2c0::ic_tar::GC_OR_START_A

pub enum GC_OR_START_A {
    GENERAL_CALL = 0,
    START_BYTE = 1,
}

If bit 11 (SPECIAL) is set to 1 and bit 13(Device-ID) is set to 0, then this bit indicates whether a General Call or START byte command is to be performed by the DW_apb_i2c. - 0: General Call Address - after issuing a General Call, only writes may be performed. Attempting to issue a read command results in setting bit 6 (TX_ABRT) of the IC_RAW_INTR_STAT register. The DW_apb_i2c remains in General Call mode until the SPECIAL bit value (bit 11) is cleared. - 1: START BYTE Reset value: 0x0

Value on reset: 0

Variants

GENERAL_CALL = 0

0: GENERAL_CALL byte transmission

START_BYTE = 1

1: START byte transmission

Trait Implementations

impl Clone for GC_OR_START_A

fn clone(&self) -> GC_OR_START_A

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for GC_OR_START_A

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl From<GC_OR_START_A> for bool

fn from(variant: GC_OR_START_A) -> Self

Converts to this type from the input type.

impl PartialEq for GC_OR_START_A

fn eq(&self, other: &GC_OR_START_A) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for GC_OR_START_A

impl Eq for GC_OR_START_A

impl StructuralPartialEq for GC_OR_START_A