Enum TX_ABRT_A

pub enum TX_ABRT_A {
    INACTIVE = 0,
    ACTIVE = 1,
}

This bit indicates if DW_apb_i2c, as an I2C transmitter, is unable to complete the intended actions on the contents of the transmit FIFO. This situation can occur both as an I2C master or an I2C slave, and is referred to as a ‘transmit abort’. When this bit is set to 1, the IC_TX_ABRT_SOURCE register indicates the reason why the transmit abort takes places.

Note: The DW_apb_i2c flushes/resets/empties the TX_FIFO and RX_FIFO whenever there is a transmit abort caused by any of the events tracked by the IC_TX_ABRT_SOURCE register. The FIFOs remains in this flushed state until the register IC_CLR_TX_ABRT is read. Once this read is performed, the Tx FIFO is then ready to accept more data bytes from the APB interface.

Reset value: 0x0

Value on reset: 0

Variants

INACTIVE = 0

0: TX_ABRT interrupt is inactive

ACTIVE = 1

1: TX_ABRT interrupt is active

Trait Implementations

impl Clone for TX_ABRT_A

fn clone(&self) -> TX_ABRT_A

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for TX_ABRT_A

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl From<TX_ABRT_A> for bool

fn from(variant: TX_ABRT_A) -> Self

Converts to this type from the input type.

impl PartialEq for TX_ABRT_A

fn eq(&self, other: &TX_ABRT_A) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for TX_ABRT_A

impl Eq for TX_ABRT_A

impl StructuralPartialEq for TX_ABRT_A