Enum STOP_DET_A

pub enum STOP_DET_A {
    INACTIVE = 0,
    ACTIVE = 1,
}

Indicates whether a STOP condition has occurred on the I2C interface regardless of whether DW_apb_i2c is operating in slave or master mode.

In Slave Mode: - If IC_CON[7]=1’b1 (STOP_DET_IFADDRESSED), the STOP_DET interrupt will be issued only if slave is addressed. Note: During a general call address, this slave does not issue a STOP_DET interrupt if STOP_DET_IF_ADDRESSED=1’b1, even if the slave responds to the general call address by generating ACK. The STOP_DET interrupt is generated only when the transmitted address matches the slave address (SAR). - If IC_CON[7]=1’b0 (STOP_DET_IFADDRESSED), the STOP_DET interrupt is issued irrespective of whether it is being addressed. In Master Mode: - If IC_CON[10]=1’b1 (STOP_DET_IF_MASTER_ACTIVE),the STOP_DET interrupt will be issued only if Master is active. - If IC_CON[10]=1’b0 (STOP_DET_IFADDRESSED),the STOP_DET interrupt will be issued irrespective of whether master is active or not. Reset value: 0x0

Value on reset: 0

Variants

INACTIVE = 0

0: STOP_DET interrupt is inactive

ACTIVE = 1

1: STOP_DET interrupt is active

Trait Implementations

impl Clone for STOP_DET_A

fn clone(&self) -> STOP_DET_A

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for STOP_DET_A

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl From<STOP_DET_A> for bool

fn from(variant: STOP_DET_A) -> Self

Converts to this type from the input type.

impl PartialEq for STOP_DET_A

fn eq(&self, other: &STOP_DET_A) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for STOP_DET_A

impl Eq for STOP_DET_A

impl StructuralPartialEq for STOP_DET_A