Module sie_ctrl

SIE control register

Structs

SIE_CTRL_SPEC

SIE control register

Type Aliases

DIRECT_DM_R

Field DIRECT_DM reader - Direct control of DM

DIRECT_DM_W

Field DIRECT_DM writer - Direct control of DM

DIRECT_DP_R

Field DIRECT_DP reader - Direct control of DP

DIRECT_DP_W

Field DIRECT_DP writer - Direct control of DP

DIRECT_EN_R

Field DIRECT_EN reader - Direct bus drive enable

DIRECT_EN_W

Field DIRECT_EN writer - Direct bus drive enable

EP0_DOUBLE_BUF_R

Field EP0_DOUBLE_BUF reader - Device: EP0 single buffered = 0, double buffered = 1

EP0_DOUBLE_BUF_W

Field EP0_DOUBLE_BUF writer - Device: EP0 single buffered = 0, double buffered = 1

EP0_INT_1BUF_R

Field EP0_INT_1BUF reader - Device: Set bit in BUFF_STATUS for every buffer completed on EP0

EP0_INT_1BUF_W

Field EP0_INT_1BUF writer - Device: Set bit in BUFF_STATUS for every buffer completed on EP0

EP0_INT_2BUF_R

Field EP0_INT_2BUF reader - Device: Set bit in BUFF_STATUS for every 2 buffers completed on EP0

EP0_INT_2BUF_W

Field EP0_INT_2BUF writer - Device: Set bit in BUFF_STATUS for every 2 buffers completed on EP0

EP0_INT_NAK_R

Field EP0_INT_NAK reader - Device: Set bit in EP_STATUS_STALL_NAK when EP0 sends a NAK

EP0_INT_NAK_W

Field EP0_INT_NAK writer - Device: Set bit in EP_STATUS_STALL_NAK when EP0 sends a NAK

EP0_INT_STALL_R

Field EP0_INT_STALL reader - Device: Set bit in EP_STATUS_STALL_NAK when EP0 sends a STALL

EP0_INT_STALL_W

Field EP0_INT_STALL writer - Device: Set bit in EP_STATUS_STALL_NAK when EP0 sends a STALL

KEEP_ALIVE_EN_R

Field KEEP_ALIVE_EN reader - Host: Enable keep alive packet (for low speed bus)

KEEP_ALIVE_EN_W

Field KEEP_ALIVE_EN writer - Host: Enable keep alive packet (for low speed bus)

PREAMBLE_EN_R

Field PREAMBLE_EN reader - Host: Preable enable for LS device on FS hub

PREAMBLE_EN_W

Field PREAMBLE_EN writer - Host: Preable enable for LS device on FS hub

PULLDOWN_EN_R

Field PULLDOWN_EN reader - Host: Enable pull down resistors

PULLDOWN_EN_W

Field PULLDOWN_EN writer - Host: Enable pull down resistors

PULLUP_EN_R

Field PULLUP_EN reader - Device: Enable pull up resistor

PULLUP_EN_W

Field PULLUP_EN writer - Device: Enable pull up resistor

R

Register SIE_CTRL reader

RECEIVE_DATA_R

Field RECEIVE_DATA reader - Host: Receive transaction (IN to host)

RECEIVE_DATA_W

Field RECEIVE_DATA writer - Host: Receive transaction (IN to host)

RESET_BUS_R

Field RESET_BUS reader - Host: Reset bus

RESET_BUS_W

Field RESET_BUS writer - Host: Reset bus

RESUME_R

Field RESUME reader - Device: Remote wakeup. Device can initiate its own resume after suspend.

RESUME_W

Field RESUME writer - Device: Remote wakeup. Device can initiate its own resume after suspend.

RPU_OPT_R

Field RPU_OPT reader - Device: Pull-up strength (0=1K2, 1=2k3)

RPU_OPT_W

Field RPU_OPT writer - Device: Pull-up strength (0=1K2, 1=2k3)

SEND_DATA_R

Field SEND_DATA reader - Host: Send transaction (OUT from host)

SEND_DATA_W

Field SEND_DATA writer - Host: Send transaction (OUT from host)

SEND_SETUP_R

Field SEND_SETUP reader - Host: Send Setup packet

SEND_SETUP_W

Field SEND_SETUP writer - Host: Send Setup packet

SOF_EN_R

Field SOF_EN reader - Host: Enable SOF generation (for full speed bus)

SOF_EN_W

Field SOF_EN writer - Host: Enable SOF generation (for full speed bus)

SOF_SYNC_R

Field SOF_SYNC reader - Host: Delay packet(s) until after SOF

SOF_SYNC_W

Field SOF_SYNC writer - Host: Delay packet(s) until after SOF

START_TRANS_R

Field START_TRANS reader - Host: Start transaction

START_TRANS_W

Field START_TRANS writer - Host: Start transaction

STOP_TRANS_R

Field STOP_TRANS reader - Host: Stop transaction

STOP_TRANS_W

Field STOP_TRANS writer - Host: Stop transaction

TRANSCEIVER_PD_R

Field TRANSCEIVER_PD reader - Power down bus transceiver

TRANSCEIVER_PD_W

Field TRANSCEIVER_PD writer - Power down bus transceiver

VBUS_EN_R

Field VBUS_EN reader - Host: Enable VBUS

VBUS_EN_W

Field VBUS_EN writer - Host: Enable VBUS

W

Register SIE_CTRL writer